Any tips for setting up a SL15, load,vtf,etc.
or is it suck it and see.
SPU-SL15
#2
Well I sucked it and then found this on an old Ebay listing.
Weight of Pickup Cartridge..............................7 Grams
Output impedence........................................... 2 Ohms
Recommended load impedence per channel..... 1.5 Ohms
Equivalent mass (at stylus point)....................... 0.9 Mgs.
Recommended stylus pressure......................... 3/4 - 1 1/2 Grams
Output in MV/CM/Sec (loaded)..................... 0.04 MV.
Stylus Tip Radius - Eliptical............................. .0007" x .0003"
Frequency Response...................................... 10-40,000 HZ
Vertical Tracking Angle.................................. 15 Degrees
Channel Seperation at 1000 HZ..................... 20-30 db.
I settled on 1.3 gram and the Cinemag SUT works well on +36, cartridge output 0.04mv
Weight of Pickup Cartridge..............................7 Grams
Output impedence........................................... 2 Ohms
Recommended load impedence per channel..... 1.5 Ohms
Equivalent mass (at stylus point)....................... 0.9 Mgs.
Recommended stylus pressure......................... 3/4 - 1 1/2 Grams
Output in MV/CM/Sec (loaded)..................... 0.04 MV.
Stylus Tip Radius - Eliptical............................. .0007" x .0003"
Frequency Response...................................... 10-40,000 HZ
Vertical Tracking Angle.................................. 15 Degrees
Channel Seperation at 1000 HZ..................... 20-30 db.
I settled on 1.3 gram and the Cinemag SUT works well on +36, cartridge output 0.04mv
- Paul Barker
- Social Sevices have been notified
- Posts: 8998
- Joined: Mon May 21, 2007 9:42 pm
#3
I think I have one, very low output makes a heck of a raket, not exceptional sound. prefer the transformer one.