OB with Alpair 12P and Eminence Beta 15
#31 Re: OB with Alpair 12P and Eminence Beta 15
A few of us have OB's with either Alphas or Betas, the Betas seem to resolve more detail then the Alphas to my ears.
#32 Re: OB with Alpair 12P and Eminence Beta 15
As Ali said, the choice of Betas over Alphas is partly a subjective preference having heard them. Also, as I said earlier in the thread, I don't want to energise the room mode at 40 Hz. The Alpha with fs at 41Hz and Qts of 1.26 would be asking for trouble. I haven't finally decided on Betas yet. I'm a little worried by the low impedance when connected in parallel. I may try simulating some of the 4ohm or 16ohm Eminence drivers.MJK wrote: ↑Sun Jul 02, 2017 2:58 pm OK, your plots make sense now.
Looking at your final plot, which produces the deepest bass output, you are using two Beta 15A woofers with a lower crossover point producing about 95 dB/2.83 V/m down to about 50 Hz. I have a very similar simulation that produces a little more output (96 dB/2.83 V/m) using two Alpha 15A woofers and a higher (less expensive) crossover frequency.
In summary, I think you can get the same low frequency results using less expensive woofers and crossover components. What performance advantage are you gaining by using the Beta 15A woofers?
#33 Re: OB with Alpair 12P and Eminence Beta 15
Yes, I'm hoping so. Fingers crossedMJK wrote: ↑Sun Jul 02, 2017 2:58 pm With respect to the sound being course during break in of the Alpair 12P with a full range signal, I think the performance of the full range driver will improve significantly once you remove the low frequency signal and redirect it to the big woofers. A high pass crossover on the Alpair 12P driver will clean up the performance and relieve low frequency strain on the full range driver
#34 Re: OB with Alpair 12P and Eminence Beta 15
Does anyone have any experience with the Eminence Delta 15?
They are available in a 16 ohm version. I'm thinking I could run two in parallel and get a decent impedance.....
They are available in a 16 ohm version. I'm thinking I could run two in parallel and get a decent impedance.....
- IslandPink
- Amstrad Tower of Power
- Posts: 10041
- Joined: Tue May 29, 2007 7:01 pm
- Location: Denbigh, N.Wales
#35 Re: OB with Alpair 12P and Eminence Beta 15
16 ohm one has higher resonant frequency at 45Hz , won't go quite as low as the Betas.
"Once you find out ... the Circumstances ; then you can go out"
#36 Re: OB with Alpair 12P and Eminence Beta 15
I hadn't
I'm having a bit of paralysis by analysis here....
I'd like to just buy a few pairs of different drivers and try them all, but I'm really having to watch the pennies....
Maybe I'll try to sell some stuff that I'm never going to use to raise a bit of cash
I hadn't spotted that, thanks Mark.IslandPink wrote: ↑Mon Jul 10, 2017 7:45 pm 16 ohm one has higher resonant frequency at 45Hz , won't go quite as low as the Betas.
I'm having a bit of paralysis by analysis here....
I'd like to just buy a few pairs of different drivers and try them all, but I'm really having to watch the pennies....
Maybe I'll try to sell some stuff that I'm never going to use to raise a bit of cash
#37 Re: OB with Alpair 12P and Eminence Beta 15
Mark has a good point you want as low an fs as you can get,
But it has a big magnet and double the bl which generally is a speaker that's faster with more life.
Weight and strength of the magnet usually relates to the cost of the speaker
It's important to look at the response graph (and see how it's measured) to check it's going to do what you want with no big peaks in the frequencies where you want to use it.. look on blue Aaron's website if you have not already. Do your home work and buy the best you can afford would be my advice
But it has a big magnet and double the bl which generally is a speaker that's faster with more life.
Weight and strength of the magnet usually relates to the cost of the speaker
It's important to look at the response graph (and see how it's measured) to check it's going to do what you want with no big peaks in the frequencies where you want to use it.. look on blue Aaron's website if you have not already. Do your home work and buy the best you can afford would be my advice
The tube manual is quite like a telephone book. The number of it perfect. It is useful to make it possible to speak with a girl. But we can't see her beautiful face from the telephone number
#38 Re: OB with Alpair 12P and Eminence Beta 15
Max,
Have you had a look at the Monacor range of 18" and 15" woofers? http://www.monacor.co.uk/categories/speaker-technology/
I'm not up on the price of the Eminence drivers but I can get you any the Monacor drivers at Trade price.
Send me a email of any the drivers that look to meet your requirements and I'll advice you the trade price. These I can have delivered direct to you.
Regards
Colin
Have you had a look at the Monacor range of 18" and 15" woofers? http://www.monacor.co.uk/categories/speaker-technology/
I'm not up on the price of the Eminence drivers but I can get you any the Monacor drivers at Trade price.
Send me a email of any the drivers that look to meet your requirements and I'll advice you the trade price. These I can have delivered direct to you.
Regards
Colin
- IslandPink
- Amstrad Tower of Power
- Posts: 10041
- Joined: Tue May 29, 2007 7:01 pm
- Location: Denbigh, N.Wales
#39 Re: OB with Alpair 12P and Eminence Beta 15
Yes, but ....again ....
The speed and life bit is supposed to be being provided by the midrange driver.
If you want a driver that's going to be an OB bass driver it doesn't want a really bit magnet and a high BL. If you get one like that, it's more of a midrange driver when used on OB because it'll just have a rising response from the bass through to about 300Hz or more. Then you'll have more trouble crossing to eg. the Alpair, and need EQ from 150 down to 50Hz .
This sort of driver is more suited to ported box.
What you want is a driver with the RIGHT SIZED MAGNET to balance against the cone mass to give you a flat response in the upper bass and lower mids when used on a big baffle or infinite baffle as per the datasheet. Look at the datasheet FR of the Beta 15A - it's overall flat from 100Hz to 500Hz. When you use a bit choke as per the Quasar you pull the response down above 100Hz and all it sort-of pivots clockwise around 100Hz so you get relatively more bass below 100Hz than on the datasheet curve.
What you've had to do with your 18" unit on the latest build is load it with undersized ports, which is precisely because it's a large-magnet driver which is more suited to a ported box than OB use.
"Once you find out ... the Circumstances ; then you can go out"
#40 Re: OB with Alpair 12P and Eminence Beta 15
Thanks Colin I'll take a lookToppsy wrote: ↑Tue Jul 11, 2017 9:05 am Max,
Have you had a look at the Monacor range of 18" and 15" woofers? http://www.monacor.co.uk/categories/speaker-technology/
I'm not up on the price of the Eminence drivers but I can get you any the Monacor drivers at Trade price.
Send me a email of any the drivers that look to meet your requirements and I'll advice you the trade price. These I can have delivered direct to you.
Regards
Colin
- pre65
- Amstrad Tower of Power
- Posts: 21399
- Joined: Wed Aug 22, 2007 11:13 pm
- Location: North Essex/Suffolk border.
#41 Re: OB with Alpair 12P and Eminence Beta 15
The only thing necessary for the triumph of evil is for good men to do nothing.
Edmund Burke
G-Popz THE easy listening connoisseur. (Philip)
Edmund Burke
G-Popz THE easy listening connoisseur. (Philip)
#42 Re: OB with Alpair 12P and Eminence Beta 15
Thanks both, all this input is very helpful. I know the above quotes are selective, but I'm actually taking in all that you've said and it is clarifying my thoughts, if that makes senseIslandPink wrote: ↑Tue Jul 11, 2017 7:08 pm What you want is a driver with the RIGHT SIZED MAGNET to balance against the cone mass to give you a flat response in the upper bass and lower mids when used on a big baffle or infinite baffle as per the datasheet. Look at the datasheet FR of the Beta 15A - it's overall flat from 100Hz to 500Hz. When you use a bit choke as per the Quasar you pull the response down above 100Hz and all it sort-of pivots clockwise around 100Hz so you get relatively more bass below 100Hz than on the datasheet curve.
- IslandPink
- Amstrad Tower of Power
- Posts: 10041
- Joined: Tue May 29, 2007 7:01 pm
- Location: Denbigh, N.Wales
#43 Re: OB with Alpair 12P and Eminence Beta 15
I know, there's a tendency to think you could spend more money and get something better ( eg. with Eminence ) but at the end of the day you have to have the right parameters for the job. There are plenty of 15" drivers there with bigger magnets , lower Qt and greater power handling ; but what are you going to hear in your room on a limited-sized OB at room-level power inputs ? I've looked through most of the Eminence range and there's nothing I can see at present that does the job on OB quite as well as the Beta 15A.
If you want to spend more money, get a pair of these and run them at around 9V supply to the electromagnets
http://www.supravox.fr/anglais/haut_par ... 00_EXC.htm
I will have a look through Colin's link to the Monacor's , though. There were a couple that looked interesting. As usual though, it was the cheaper ones with the limited power handling and the smaller magnets ..
Steve - sorry to labour this point, but look at the magnet size on the Supravox 285GMF ( it's under a fancy cover and is not that big ) and note the BL, which is around 10.
Edit : yes, I think the Supravox 400_2000_EXC is the best OB bass unit you could buy , look at the data here :
http://www.supravox.fr/anglais/mesures/mes400EXC1.htm
Clean out to 3kHz..
Be the first one on the forum to own one, Max !!
If you want to spend more money, get a pair of these and run them at around 9V supply to the electromagnets
http://www.supravox.fr/anglais/haut_par ... 00_EXC.htm
I will have a look through Colin's link to the Monacor's , though. There were a couple that looked interesting. As usual though, it was the cheaper ones with the limited power handling and the smaller magnets ..
Steve - sorry to labour this point, but look at the magnet size on the Supravox 285GMF ( it's under a fancy cover and is not that big ) and note the BL, which is around 10.
Edit : yes, I think the Supravox 400_2000_EXC is the best OB bass unit you could buy , look at the data here :
http://www.supravox.fr/anglais/mesures/mes400EXC1.htm
Clean out to 3kHz..
Be the first one on the forum to own one, Max !!
"Once you find out ... the Circumstances ; then you can go out"
#45 Re: OB with Alpair 12P and Eminence Beta 15
Thanks Phil, but I won't get away with 18"ers. I need to end up with something acceptable to my other halfpre65 wrote: ↑Tue Jul 11, 2017 7:25 pm Max, I saw these on Ebay, he has 2 pairs.
http://www.ebay.co.uk/itm/Two-working-E ... 1438.l2649