audio-talk

Here's the schematic.

Populate it with components selected from the following sizes and types to suit budget and requirements.

STMICROELECTRONICS - LD1085P - V REG ADJ 1.25/28V, 1085, TO220FP3 Or other LM317 style VReg.
UF4001 Rectifier Diode 30 A or Diode of style TO220
WIMA MKS2C031001A00JSSD CAP, FILM, PET, 47NF - 100NF, 63V, RAD
FISCHER ELEKTRONIK  SK 129 50,8 STS  HEAT SINK, EXTRUDED, PCB MOUNTING (or smaller/larger)
LITTELFUSE 30R110UU POLYFUSE, PTC, RADIAL, 1.1A
LED - 5mm (any colour)
VISHAY SPRAGUE - 489D106X0016C6VE3 - CAPACITOR, TANTALUM, 16V, >10UF (Minimum value of Cout - depends upon type of reg chip)
CAMDENBOSS - CTB5202/2 - TERMINALBLOCK, PCB, 2WAY, 5MM (or similar)
CAMDENBOSS - CTB5202/3 - TERMINALBLOCK, PCB, 3WAY, 5MM (or similar)
Similar PANASONIC - EEUFR1C472 - CAP, ALU ELEC, 5600UF/4700UF, 16V or single capacitor of similar to MULTICOMP - MCLPR16V109M22X25 - CAPACITOR, 10000UF, 16V

Feel free to suggest alternatives.

Andrew

PLEASE BE AWARE.

The symbols, well spotted Simon, are the wrong way up on the two by pass cap locations, the negative pins are the lower ones and the positive the upper ones, you can see my mistake on the above schemtic - assuming you're reading the screen print writing the correct way up put the caps in so that the negative pin is the lower pin towards the bottom edge.

The PCB is fine, of course, its just the labeling.

Andrew

Attached is a trace of the circuit including component numbering. Not all the traces are included, the bridge bypass caps for instance, and I haven't included the ground connections as it would make it complicated.

Useful if you want to go off piste from Andrew's circuit.

Excellent!