pentode screens

We all start somewhere
User avatar
Mike H
Amstrad Tower of Power
Posts: 19061
Joined: Sat Oct 04, 2008 5:38 pm
Location: The Fens
Contact:

#16 Re: pentode screens

Post by Mike H »

Audible effects might be due to there being a capacitor across the filament, and not actually the HF – e.g. the Coleman reg doesn't do that (put a cap across the o/p). And probably also, what kind of cap. Hence my idea for using a series resistor as an attempt at isolation. A small value choke may not hurt either, bearing in mind an AC heater winding on a mains transformer is also a low value choke.
 
"Entrenched convictions cannot be changed by facts." – Dick Francis
User avatar
IslandPink
Social Sevices have been notified
Posts: 8834
Joined: Tue May 29, 2007 7:01 pm
Location: Denbigh, N.Wales

#17 Re: pentode screens

Post by IslandPink »

Maybe ther eare other explanations Mike, but there's plenty of scope for the (eg) 60kHz ( and it's typical 50mV ) to intermodulate with the audio signal in the 5-10kHz area, and produce side-bands. It may be worth tinkering with some calcs to use a small choke in series and a cap across the filament to get a low-pass filter that cuts the 50 to 60KHz down by eg a factor of 5 or more. What you do want to avoid ( from the Lehane fil work ) is having the output impedance of the supply ramping up or down significantly anywhere within the audio band. That just kills the tone for an octave or two. wherever it occurs.
"Peridots and periwinkle, blue medallions Gilded galleons spilled across the ocean floor" ( Mitchell )
User avatar
Mike H
Amstrad Tower of Power
Posts: 19061
Joined: Sat Oct 04, 2008 5:38 pm
Location: The Fens
Contact:

#18 Re: pentode screens

Post by Mike H »

Yes understood
 
"Entrenched convictions cannot be changed by facts." – Dick Francis
izzy wizzy
Old Hand
Posts: 1368
Joined: Fri Nov 02, 2007 7:02 pm
Location: Auckland NZ
Contact:

#19 Re: pentode screens

Post by izzy wizzy »

I was looking at some application notes from Murata https://www.murata.com/~/media/webrenew ... 6to30.ashx to get a handle on this stuff. I thought the CM choke helped, about 8mH @ 4A rated from memory for GM70. Was going to try 3 terminal capacitor as well and then found combination units at Farnell of CM choke and 3 term cap all in one module (didn't buy it). I had some resistors in there before all that to drop voltage before the CM choke and thought it was headed in the right direction. IIRC, this stuff is designed to work in the range of frequencies we're interested in. I still may fiddle with some of this before the Lehane regs at some point to see what happens.
Post Reply