audio-talk

Belt and braces tbh. Just use the two 270 and try connecting the cathodes and see if there is any difference.

Any reason you are not using a shared cathode resistor for the second stage?

The major advantage of chokes over resistors or CCS as loads is they will swing above as well as below B+. So you need to have more B+ for resistors. In that circuit you may have enough B+ as you are dropping some of it in the 5k resistor. The other advantage is the added balancing action of the ...

I am sure it was a rhetorical question but

Resistors and coupling caps; Who said they need fixing

I think almost entirely you.

Those ccs. as sold by Kevin, I thought that too so I didn't, but later maybe. In other similar applications a ccs on the anode or cathode added great sound quality, so perhaps they are ( always) better!? I'll never get round to it.


That sounds a bit like a version of:

No one I think is in my ...

So remove the center tapped choke and use to resistors. Ok, standard PP driver stage. Not sure where the CCS's come into it?

Nick, so actually I could use a two power resistors of the value required and b+ to centre tap? Or just use the ccs and have a horizontal. Loadline?

I would have to see a schematic to know what exactly you are suggesting.

I may be getting confused here, but if you are using a choke load, then the inductance not the impedance is what matters. Impedance only makes sense if there is a load on the secondary that is reflected to the primary. When you have a choke load only, then there is no load line as you would have ...

Can we just be clear here:

But when I was measuring distortion

You are not measuring anything, all you are doing is using some curves to estimate what might happen. Its just a very (very) simplified version of what spice does.

andrew Ivimey wrote: Wed Dec 11, 2024 10:01 am Think what Jimi did with distortion!!!!

True, but unhelpful

Just to be picky:

The 45 probably has other sound qualities to mitigated its distortion.

Exactly what could those "sound qualities" be other than distortion?

Very nice. As you say, the HF625 does need to be run hot to get it to flow. And from the spec sheet "HI-FLOW ™ 625 is coated on both sides of the Bergquist proprietary film substrate." I think what you showed was the adhesive. The spec sheet numbers are run at 70C.

The bee in my bonnet is you guys all building pp amps full of transformers which bring additional distortions of similar type, because who said a transformer is the best coupling means? It was as big fad in my view. Any flaws in the topology are amplified by each stage of the same topology.

Then ...

Then again, the DCR of the transformer will do just as good a job with grid current. Maybe ignore that.

I would be tempted to use a pair of resistors to ground instead of a single one, would help with any grid current that occurs.