Turned this yesterday on the lathe
Currently trying to figure out how to attach a bearing cup to the top with tiny screws, and then onto the base....
Whats he up to now?
- Paul Barker
- Social Sevices have been notified
- Posts: 8988
- Joined: Mon May 21, 2007 9:42 pm
#2 Re: Whats he up to now?
What bearing design? Unipivot?
"Two things are infinite, the universe and human stupidity, and I am not yet completely sure about the universe." – Albert Einstein
- cressy
- Shed dweller
- Posts: 2906
- Joined: Fri Aug 03, 2007 7:07 pm
- Location: the great white space
- Contact:
#3 Re: Whats he up to now?
Yes
Have been turning another one, mainly as the headshell end is a little too thin and the bearing end is abit too small to comfortably attach the plate tht the bearing cup will be machined from
Also allows me to get the headshell end higher up so that the stylus will be closer to the pivot level
Have been turning another one, mainly as the headshell end is a little too thin and the bearing end is abit too small to comfortably attach the plate tht the bearing cup will be machined from
Also allows me to get the headshell end higher up so that the stylus will be closer to the pivot level
- Mike H
- Amstrad Tower of Power
- Posts: 20189
- Joined: Sat Oct 04, 2008 5:38 pm
- Location: The Fens
- Contact:
#4 Re: Whats he up to now?
Wow ...
"No matter how fast light travels it finds that the darkness has always got there first, and is waiting for it."