audio-talk

im looking for a sled type case/enclosure for a power supply project,can anyone point me in the right direction please?

Why that type of case in particular?

doesn't have to be.

Hammond do quite a few enclosures, ranging in size from the tiny one a couple of inches square to large one about 18" wide, and do them in steel aluminium and plastic,
Philip at bluebell audio sells them and I think the smaller ones are available from maplins too,
Thats where id look first
Edit: Farnell has loads of them in stock

I’ve had a couple of these and found them very good.

http://www.ebay.co.uk/itm/DIY-box-B1506 ... 1523123797

For one reason or another, I'm rather partial to plastic cases Perspex is too fragile for my shaky drill, but these work just fine and although not a 'sled type,' they should be perfectly safe enough and if an amp is ever built into one, there's room for heatsink plates or fin types..

Works for me and my fully 'Dual mono' (mainly) headphone amp runs sweetly, pretty quietly and looks cool with all sockets on the easily drilled back panel and two red LED's on the front, one for each channel...

https://esr.co.uk/electronics/products/ ... osures.htm